10W  LED light tube,LED tube lamp,high power LED tube light

Specialty:

(1)  Built-in power supply voltage AC90－264V input, frequency 50/60 Hz, constant current output efficiency > 87%, 0.97 > PFC, and stable performance.

(2)  Silicon wafer packaging SMD LED, Epistar chip, the color temperature range 2700-7000 K, the color developing index Ra > 70.

(3)  # 6063 aluminum shell, flame retardant PC cover, the light transmittance > 92%, unique PCB circuit design, can replace the traditional fluorescent lamp brightness.

(4)  Fluorescent lamp without ultraviolet rays, LED flash, no frequency without noise, low power consumption, start, speed, seismic, belongs to the green lighting products.

Shape Structure

Diagram of degradation for Luminous

The data above has been got at a temperature of 25 celsius degree and taking 1000 hours running by a nonstop way.

Degradation of luminous flux of LED lamps depends on environmental conditions. The higher the temperature, the longer the using time, the faster luminous flux drops.

Photomatric Data

Illumination Distance/illuminance/Irradiated Area

Packing specification

Packing Dimension：L）969×(W)536×(H)548mm    100PC/CTN   37Kg

Using and installing instructions

Conventional Installation

As the chart shows, Connect the tube with the working voltage 90V~265VAC(frequency 50/60 Hz) from two end caps, , it can work after switch on.

Replacing conventional fluorescent tube

Replace traditional fluorescent lamp, need to take the rev. Hui is divided, then a short circuit, then LED lamp ballast can load fixtures are normal use.

Traditional fluorescent connection mode

LED lamp connection mode

Attentions:

(1)  Only professional electrician can install the lamp, please check the lamp very carefully before installation.

Please install the lamp follow up the installation procedure, make sure the screw has been wrested very tightly, the wires have been connected properly, .Please operate accordingly.