Product Appearance

Specialty:

1, Using high power integrating LED, the lamp’s luminous efficiency can reach 70~80LM/W, and CRI>80Ra;Fins heating dissipation design enables the LED Tj within 85, and power up to 200W, lifespan more than 35,000 hours; with protecting rate:IP65.

 2, The UFO high bay light is verified and certified according to standards for safety as below:GB3836.1-2010 Explosive atmospheres Part 1: Equipment General Requirements GB3836.8-2003 Explosive atmospheres Part8:Electrical apparatus for explosive gas atmos-pheres-Part8:Encapsulation “n” with Ex-marking ExnRⅡT4Gc.

 3, the light can be used in: Normally, a place in which an explosive atmosphere in the form of explosive dust or combustible fiber in mixture with air is likely to occur continuously or frequently in short time, or for long periods in normal operation. According to the classification of explosion proof grade and application, the light can be use in Zone2.Surface temperature of item for safety:≤135℃,such an area lighting site like factory,warehouse,except mine.

Shape Structure

Parameters

Luminous flux reduction diagram

1,The data above was testing at environment temperature of 25 celsius degree after 1000 hours constant lighting.

2,The environment condition will affects luminous flux reduction. Luminous flux will drops faster at a higher temprature or a longer lighting time.

Photomatric Data

Illumination Distance/illuminance/Irradiated Area

Packing specification

Body（L）412×(W)312×(H)558mm    1PC/CTN    15.5Kg

Reflector（L）472×(W)472×(H)299mm    10PCS/CTN   4.5Kg

Using and installation instructions

Installation Procedures

1,Please firstly install the reflector properly on the heat sink, and screw down.

2,Then screw down the hoop into the top cap.

3,Hang the body lamp on the installation site.

4,Please hang the chaining steel wire on another installation device.

5,Connect Live Wire/Null Wire/Ground Wire to electric cable properly and switch on.

Attentions:

1, A licensed electrician must undertake this installation. Please check the lamp carefully  before installation，Forbidden to open the lid when charged;

2, Please follow up the installation procedures, make sure the screws been wrested very tightly, the wires been connected properly, as attached installation instruction.